Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - slazenger01

Pages: [1]
Hardware / Making the openlapse triggering Nikon Cameras
« on: September 26, 2018, 01:52:56 PM »
After successfully rebuilding the electronics i faced the obstacle that it canīt trigger my Nikonīs (D5200 and D200) but i finally found a easy way to solve this.

All which has to be done is to make a bridge between the focus and the shutter contact. (However you wanna do it)

This helped me finding the Solution:

i hope this will help other people to get their own projects to run with Nikon Cameras.

Hardware / Re: Problem getting the motor to run
« on: September 08, 2018, 09:27:37 AM »
Hi Folks,
just to let you know:

I was able to flash the motor shield myself now by using a "FTDI Adapter FT232RL USB to TTL Serial for 3,3V and 5V for Arduino PRO Mini TE203" Adapter and following the Tutorial from the last post.

Here are the Results:

pi@raspberrypi:~/wemos_motor_shield $ stm32flash /dev/ttyUSB0 -v -w motor_shield.bin
stm32flash 0.5

Using Parser : Raw BINARY
Interface serial_posix: 57600 8E1
Version      : 0x31
Option 1     : 0x00
Option 2     : 0x00
Device ID    : 0x0444 (STM32F03xx4/6)
- RAM        : Up to 4KiB  (2048b reserved by bootloader)
- Flash      : Up to 32KiB (size first sector: 4x1024)
- Option RAM : 16b
- System RAM : 3KiB
Write to memory
Erasing memory
Wrote and verified address 0x08000c4c (100.00%) Done.

YAY :)

 i am very happy and proud that i made it - hopefully it works when all is assembled

Hardware / Re: Problem getting the motor to run
« on: September 07, 2018, 09:44:29 AM »
Meanwhile i found a tutorial which tells how to flash the Motor board without soldering:

best regars

Software / Re: Flashing the motor shield
« on: September 06, 2018, 01:43:45 PM »
Does anybody know which one is the right device?
has anybody flashed the controller board already?

Hardware / Flashing the controller board
« on: September 06, 2018, 01:39:00 PM »
Hi Folks,

i already managed to flash the Wifi board, but now i read here that flashing the motor controller is also neccesary.
How can thi sbe done?
Does anyone can tell me (step by step, please) how to do this and what i need besides the controller board itself.

thanks in advance

Pages: [1]